Mazda CX-5 Service & Repair Manual: Forced Induction

Presilencer

Purpose, Function Reduces the exhaust noise. Construction The presilencer is installed to the rear of the TWC. 2WD AWD The presilencer consists of the filte ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]

Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the ...

Other materials:

Antenna Feeder No.3 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. B-pillar lower trim. b. Front seat belt adjusting cover. c. Front seat belt upper anchor installation bolt. d. B-pillar upper trim. e. Trunk board. f. Trunk end trim. g. Trunk side trim. h. D-pillar trim. ...

Meter Hood Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the upper column cover. 3. Using a phillips screwdriver, remove fasteners. NOTE: When pulling up the shaft of fasteners using a phillips screwdriver, the shaft will not be pulled up if it is rotated by pressing the driver. To pull ...

Clock Spring Inspection [Standard Deployment Control System]
1. Disconnect the negative battery cable and wait for 1 min or more.. 2. Remove the driver?side air bag module.. 3. Remove the steering wheel.. 4. Remove the column cover.. 5. Remove the clock spring.. 6. Verify that the continuity is as indicated in the table. If not as indicated ...