Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Fuel Pressure Sensor Inspection

Mazda CX-5 Service & Repair Manual / Engine / Fuel / Fuel Pressure Sensor Inspection

Voltage Inspection

NOTE:

1. Connect the M-MDS to the DLC?2.

2. Switch the ignition ON (engine off or on).

3. Verify that the fuel pressure sensor output voltage (PID: FUEL_PRES) is within the specification..

Specification


Returnless Fuel System
Purpose, Outline Fuel evaporation in the fuel tank is reduced by adjusting the fuel amount (fuel pressure) ejected from the fuel pump and preventing fuel warmed in the engine compartment ...

Fuel Pressure Sensor
Purpose/Function Detects the fuel pressure in the fuel distributor as basic information for mainly determining the fuel injection amount. Detects the fuel pressure in the fuel distri ...

Other materials:

Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Drain the engine coolant.. 4. Pull out the evaporati ...

Identification Numbers
Vehicle Information Labels Vehicle Identification Number The vehicle identification number legally identifies your vehicle. The number is on a plate attached to the left top side of the dashboard. This plate can easily be seen through the windshield. Motor Vehicle Safety Standard Label ...

Fuse Block
Purpose Fuses used by each system are grouped and housed together for smooth inspection and replacement servicing. Function Fuses used by each system are grouped and housed together. Construction Installed inside the front side trim (LH). Operation Fu ...

© 2016-2026 Copyright www.mcx5.org