Mazda CX-5 Service & Repair Manual: Sensors, Switches, Relays
- Brake Fluid Level Sensor Inspection
- Brake Switch Inspection
- Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Parking Brake Switch Inspection
1. Disconnect the parking brake switch connector.
2. Verify that the continuity is as indicated in the table.
If not as indicated in the table, replace the parking brake switch.
...
Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder.
2. Inspect for continuity according to fluid level between the brake fluid level
sensor terminals.
If no ...
Other materials:
Manual Transaxle Oil Inspection [C66 M R]
1. Park the vehicle on level ground.
2. Remove the front under cover No.2..
3. Remove the oil level plug and gasket.
4. Verify that the manual transaxle oil is near the brim of the plug port.
When the manual transaxle oil level is lower than the lower limit, add manual
transaxl ...
Fuel Tank
Purpose, Function
Store fuel safely and supply fuel to the engine.
Construction
U.S.A. and CANADA
The fuel tank is installed below the rear seat.
2WD
AWD
The fuel tank is made of steel.
The following parts are integrated in the fuel tank.
...
Power Outer Mirror Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Insert a tape-wrapped flathead screwdriver into the service hole and remove
hooks A in the direction of arrow (1).
5. Slide the service hole cover in the direction of the arrow ( ...
