Mazda CX-5 Service & Repair Manual: Tcs/DSC Indicator Light
Purpose/Function
-
The TCS/DSC indicator light, built into the instrument cluster, informs the driver of the following vehicle conditions.
-
TCS is operating. (Drive wheel is slipping.)
-
DSC is operating. (Vehicle side-slip condition.)
-
Roll over mitigation (ROM) is operating.
-
DSC system malfunction.
Operation
-
When the DSC system and CAN lines are normal, the TCS/DSC indicator light illuminates for approx. 3.0 s when the ignition is switched to ON to check the light function. When the system is malfunctioning, the TCS/DSC indicator light remains illuminated.
-
When the TCS, DSC or roll over mitigation (ROM) are non-operational, operational and malfunctioning, the TCS/DSC indicator light operates according to the following table.
TCS/DSC indicator light operation
|
Item |
TCS/DSC indicator light |
|
TCS, DSC, and roll over mitigation (ROM) not operating
|
Not illuminated |
|
TCS operating
|
Flashes (0.5 s intervals) |
|
DSC operating
|
|
|
Roll over mitigation (ROM) operating
|
|
|
DSC system malfunction
|
Illuminated |
Fail-safe
-
Function not equipped.
Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling
the TCS control at driver discretion.
The TCS OFF indicator light, built ...
Tire Pressure Monitoring System Warning Light
Purpose, Function
The tire pressure monitoring system warning light notifies the driver that
it was determined that a tire pressure has decreased below the specified value
based on the in ...
Other materials:
Engine Transaxle Integration Control [Fw6 A EL, Fw6 Ax EL]
Outline
The TCM controls engine output torque and reduces transaxle output shaft
torque fluctuation during auto shifting, and reduces shock occurring from the
vehicle during shifting.
Construction
Operation
During auto shifting, the TCM sends the torque reduction reque ...
Throttle Body
Purpose, Function
Opens/closes the throttle valve to adjust the amount of air supplied to the
cylinder.
Opens/closes the throttle valve according to the control signal from the
PCM.
Construction
The throttle body is installed to the intake manifold.
Th ...
Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air
Conditioner]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (driver-side).
b. Front side trim (driver-side).
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear console. ...
