Turn Signal/Hazard Warning Indicator Lights
TowingCooling Fan Motor Inspection
Part Inspection
1. Verify that the battery is fully charged..
2. Disconnect the cooling fan motor connector (2 terminals).
3. Install a tester and battery to the cooling fan motor connector (2 terminals)
as shown in the figure.
4. Verify that each cooling fan motors operate smoothly at ...
Adaptive Front Lighting System (Afs) Control Module Removal/Installation
NOTE:
The AFS control module prior to replacement stores the vehicle specification
information.
A new AFS control module does not store any vehicle specification information.
When the ignition is switched ON after the AFS control module is replaced,
the AFS control modu ...
Steering Angle Sensor Inspection
1. Remove the column cover..
2. Connect the plus (+) end of a tester to steering angle sensor terminal A and
the minus (-) end of the tester to terminal B (GND).
3. Switch the ignition ON (engine off or on).
4. Turn the steering wheel to the left and right.
5. Verify that the voltage f ...