Mazda CX-5 Service & Repair Manual: Steering
- General
- General Procedures (Steering)
- Precaution
- Steering Abbreviations
- Steering Features
- Steering SST
- Steering Switch
- Steering Switch Inspection
- Steering Switch Removal/Installation
- Linkage, Power
- Electric Power Steering (Eps) Control Module
- Electric Power Steering (Eps) Motor
- Electric Power Steering System
- Eps Control Module Inspection
- Oil Control Valve (OCV) Inspection [Skyactiv G 2.0]
- Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
- Oil Control Valve (OCV) [Skyactiv G 2.0]
- Power Steering Malfunction Indicator Light
- Pressure Control Valve Inspection [Skyactiv G 2.0]
- Pressure Control Valve [Skyactiv G 2.0]
- Steering Shaft Inspection
- Tie Rod End Inspection
- Tie Rod End Replacement
- Tie Rod Inspection
- Torque Sensor
- Steering Gear And Linkage
- Steering Gear And Linkage Assembly
- Steering Gear And Linkage Disassembly
- Steering Gear And Linkage Inspection
- Steering Gear And Linkage Removal/Installation
- Wheel, Column
- Steering Column And Shaft
- Steering Shaft Inspection
- Steering Wheel And Column Inspection
- Steering Wheel And Column Removal/Installation
- Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
- Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Seat Belt Inspection
Belt
1. Verify that the belt is installed properly with no twists or kinks.
2. Verify that there is no damage to the seat belt and no deformation of the
metal fittings.
If there is any ma ...
General
...
Other materials:
Switch Panel Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the car-navigation unit. (with car-navigation system).
3. Insert your hand from the lower side of the lower panel (without car-navigation
system) or the area where the car-navigation unit was installed (with car-navigation
system), press t ...
Instrumentation/Driver Info. Personalization Features Setting Procedure
1. Connect the M-MDS to the DLC-2.
2. After vehicle identification, select the following from the M-MDS initialization
screen.
a. “Module programming“
b. “Programmable Parameters”
3. Select menu in the “IC”.
4. Select an item name, and than select option.
Instrument cluster ...
Front Fog Light Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the mudguard screws.
3. Disconnect the connector.
4. Rotate the front fog light bulb in the direction of the arrow (1) shown in
the figure and remove it from the front fog light in the direction of the arrow
(2) shown in the figu ...
