Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Intake Actuator Removal/Installation [Manual Air Conditioner]

Mazda CX-5 Service & Repair Manual / Engine / Intake / Air Intake Actuator Removal/Installation [Manual Air Conditioner]

1. Disconnect the negative battery cable..

2. Remove the glove compartment..

3. Disconnect the air intake actuator connector.


4. Remove the screw, then remove the air intake actuator.

5. Install in the reverse order of removal.

Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the glove compartment.. 3. Disconnect the air intake actuator connector. 4. Remove the screw, then remove the air intake actuator. 5. I ...

Air Intake Actuator [Full Auto Air Conditioner]
Purpose The air intake actuator moves the air intake door in the blower unit to switch the air intake port. Function The air intake actuator drives the motor based on the signal ...

Other materials:

Coupling Component Calibration Data Writing
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the toolbox of the M-MDS. Select “Chassis”. 3. Then, select items from the screen menu in the following order. Select “4WD/AWD”. Select “Coupling Calibra ...

Clock Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Front console box. c. Shift panel. d. Upper panel. e. Rear console. f. Side wall. g. Decoration panel. h. Front console. i. Glove compartment. j. Climate control unit. 3. C ...

On/Off Solenoid Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes. ...

© 2016-2026 Copyright www.mcx5.org