Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Ambient Temperature Sensor Removal/Installation [Manual Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Ambient Temperature Sensor Removal/Installation [Manual Air Conditioner]

1. Disconnect the negative battery cable..

2. Remove the front bumper..

3. Disconnect the connector.


4. Remove the ambient temperature sensor.

5. Install in the reverse order of removal.

Ambient Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the connector. 4. Remove the ambient temperature sensor. 5. Install in the reverse order of removal. ...

Ambient Temperature Sensor [Full Auto Air Conditioner]
Purpose The ambient temperature sensor detects the ambient temperature. Function The ambient temperature sensor converts the detected temperature to an electric signal. Co ...

Other materials:

Liftgate Upper Trim Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the liftgate upper trim in the direction of the arrow (1) shown in the figure, then detach clips B, clip C and pin D while pulling in the direction of the arrow (2). 2. Take the shaded area shown in the figure, detach ...

Rear Shock Absorber Disposal
WARNING: Whenever drilling into a rear shock absorber, wear protective eye wear. The gas in the rear shock absorber is pressurized, and could spray metal chips into the eyes and face when drilling. 1. Clamp a rear shock absorber on a flat surface or with the piston pointing ...

Front Door Latch And Lock Actuator Removal/Installation
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Inner handle. d. Front door glass. e. Front door module panel. f. Front door key cylinder. 4. Remove the door lock knob c ...

© 2016-2025 Copyright www.mcx5.org