Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: HVAC

Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The oil pressure switch detects the engagement pressures of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch. The oil pressure switch signal is used for a ...

General
...

Other materials:

Start Stop Unit Configuration (Using Read/Write Function)
NOTE: When performing configuration, it is necessary to read the vehicle specification information from the start stop unit before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the start stop unit. The vehicle specification informa ...

Blower Unit Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (passenger-side). b. Front side trim (passenger-side). c. Dashboard under cover. d. Glove compartment. e. Decoration panel. f. Lower panel (passenger-side). 3. Disconnect the blower motor c ...

Rear Lateral Link Removal/Installation
1. Disconnect the rear stabilizer control link lower side nut.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the wheel alignment and adjust it if necessary.. 1 Rear lateral link outer bolt ...

© 2016-2026 Copyright www.mcx5.org