Purpose
The blind spot monitoring (BSM) system can be turned on or off optionally by the driver.
Function
The switch operation signal is sent to the instrument cluster.
Construction
The BSM OFF switch is built into the cluster switch.
The resistance is built into each switch.

Operation
When the BSM OFF switch operates, the switch operation signal is sent to the instrument cluster.
The instrument cluster sends a BSM OFF switch operation signal to the BSM control module based on the received voltage value (switch operation signal).
The BSM control module switches the BSM system on/off when it receives the BSM OFF switch operation signal from the instrument cluster.

Fail-safe
Function not equipped.
Blind Spot Monitoring (Bsm) Off Indicator Light
Blind Spot Monitoring (Bsm) Off Switch InspectionRear Body Control Module (Rbcm) Configuration (Using Read/Write Function)
NOTE:
When performing configuration, it is necessary to read the vehicle specification
information from the rear body control module (RBCM) before replacing it. Connect
the M-MDS to the vehicle and perform vehicle identification before removing
the rear body control module (RBCM). T ...
Engine Oil Level Inspection
1. Position the vehicle on level ground.
2. Warm up the engine.
3. Stop the engine and allow at least 5 min before continuing.
4. Remove the dipstick, wipe it cleanly, and reinstall it fully.
5. Remove the dipstick and verify that the oil level is between the F and L marks
on the dipstick. ...
Tachometer
Purpose
The tachometer notifies the driver of the engine speed.
Function
The instrument cluster controls the tachometer needle based on the engine
speed signal from the PCM and displays the engine speed per minute.
Construction
An analog needle display tachometer ...