Mazda CX-5 Service & Repair Manual: Safety Systems

Rear Accessory Socket Removal/Installation

1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the di ...

Active Command Modes Inspection [Blind Spot Monitoring (Bsm)]

1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules� ...

Other materials:

Construction Standard Values [Construction Standard Values]
Front view No. Measurement part Standard values (mm {in}) Maximum values (mm {in}) Minimum values (mm {in}) Side by difference (mm {in}) A 1 5.0 {0.20} 7.0 { ...

Rear Brake (Disc) Removal/Installation
1. Loosen the adjusting nut.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. After installation, add brake fluid, bleed the air, and inspect for fluid leakage.. 5. Pump the brake pedal a few times and inspect the following: The disc pa ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the output shaft (primary gear). The turbine/input shaft speed sensor and output shaft speed ...