Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Blower Motor Removal/Installation [Manual Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Blower Motor Removal/Installation [Manual Air Conditioner]

1. Disconnect the negative battery cable..

2. Remove the dashboard under cover..

3. Disconnect the connector.


4. Remove the screws.

5. Remove the blower motor.


6. Install in the reverse order of removal.

Blower Motor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the dashboard under cover.. 3. Disconnect the connector. 4. Remove the screws. 5. Remove the blower motor. 6. Install in the reve ...

Blower Motor [Full Auto Air Conditioner]
Purpose The blower motor sends airflow into the cabin. Function The blower motor rotates the blower fan to create airflow and sends out the airflow in the blower unit and A/C un ...

Other materials:

Side Air Bag Sensor Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the side air bag sensor.. 1. Switch the ignition to off. 2. Disconnec ...

General Procedures (Suspension)
Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening torque 108—147 N·m {12—14 kgf·m, 80—108 ft·lbf} Suspension Links Removal/Installation 1. For the ...

Vacuum Pump Inspection
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump.. 2. Install the vacuum gauge as shown in the figure, then check the vacuum. 3. Warn up the engine. If the pressure is less than the specification, inspect for the following. Malf ...

© 2016-2026 Copyright www.mcx5.org