Mazda CX-5 Service & Repair Manual: Fuel Shut Off Valve Inspection
U.S.A. And CANADA
NOTE:
-
The fuel shut-off valve cannot be removed and inspected as it is built into the fuel tank.
1. Perform the fuel tank inspection..
-
If there is any malfunction, replace the fuel tank.
Fuel Pump Unit
Purpose, Function
Supplies fuel in the fuel tank to the high pressure fuel pump.
Based on the control signal from the PCM, the fuel pump operates by the operation
of the fuel pump re ...
Fuel Shut Off Valve
U.S.A. And CANADA
Purpose, function
Prevents fuel from flowing to the charcoal canister during tight turns or
vehicle rollover.
Releases evaporative gas to the charcoal canister.
...
Other materials:
Timing Chain Removal/Installation
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
CAUTION:
If the camshaft is rotated with the timing chain removed and the piston at
the top dead center position, the valve may contact the piston and the engine ...
Oil Seal (Differential) Replacement [C66 M R]
1. Remove the front under cover No.2..
2. Drain the manual transaxle oil..
3. Disconnect the drive shaft (LH) from the MTX..
4. Disconnect the drive shaft (RH) from the MTX..
5. Remove the oil seal (LH).
6. Remove the oil seal (RH).
7. Using the SSTs and a hammer, tap a new oil s ...
Start Stop Unit
Purpose
Performs control of several systems based on input/output signals from switches.
Function
The start stop unit controls systems based on the input/output signals.
The functions which are controlled are as follows:
Control Table
Control ...
