Mazda CX-5 Service & Repair Manual: M Position Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
NOTE:
-
The M position switch is built into the selector lever component.
1. If the M position switch is replaced, replace the selector lever component..
M Position Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The M position switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect ...
M Position Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The M position switch detects that the selector lever is in the M position.
The M position switch signal is sent to the TCM via CAN, and is used for
manual shift con ...
Other materials:
Rear Buckle Removal/Installation
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Press the release switch, then disconnect the rear center seat belt and rear
buckle.
4. Fold down the rear seat back.
5. Remove the trunk board..
6. Remove the bolt.
7. Remo ...
Climate Control Unit Removal/Installation [Full Auto Air Conditioner]
NOTE:
The climate control unit prior to replacement stores the vehicle specification
information.
The new climate control unit does not store any vehicle specification information.
When the ignition is switched ON after the climate control unit is replaced,
the climate ...
Seat Warmer Switch Removal/Installation
NOTE:
The seat warmer switch are integrated into the climate control unit. (with
full-auto air conditioner system)
The seat warmer switch are integrated into the clock. (with manual air conditioner
system)
For the seat warmer switch removal/installation, refer to the cl ...
