Mazda CX-5 Service & Repair Manual: Glass & Windows

Under Coating [Water Proof And Rust Preventive]

The shaded areas indicated under body locations that are undercoated to prevent noise and rusting. ...

Filament Inspection

1. Switch the ignition ON (engine off). 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the tester could ...

Other materials:

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation
NOTE: Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2. 1. Disconnect the negative battery cable.. 2. Disconnect the MAP sensor/IAT sensor No.2 connector. 3. Remove the MAP sensor/IA ...

D Pillar Reinforcement (Lower) Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

Roof Molding Removal
1. Insert a tape-wrapped flathead screwdriver in the position shown in the figure. 2. Rotate a tape-wrapped flathead screwdriver in the direction of the arrow in the order of (1), (2) shown in the figure and remove the roof molding from the front T-stud. 3. Rotate the roof molding in th ...